DR Power 3-Point Hitch (April 2015 - Present) - Manual (Page 22)

22 DR ® 3-POINT HITCH TRIMMER/MOWER
Replacing the Caster Wheel
Tools Needed:
 Pliers
1. Remove the Hitch Clip with Pliers and remove the Wheel Assembly with
Spacers (Figure 42).
2. Install the new Wheel Assembly and Spacers.
3. Secure with the Hitch Clip.
Check the Tire Pressure
Tools Needed:
 Tire Pressure Gauge

Air Compressor
4. Remove the Valve Stem Protective Cap (Figure 43) and check the tire
pressure with a Tire Pressure Gauge.
5. Check what the manufacturers recommended pressure is that is stamped
on the side of the Tire.
6. If the pressure reading is too low, add air through the Valve Stem with an air
hose.
7. Replace the Valve Stem Protective Cap when finished.
Do not over inflate the tires. Inflate to the manufacturers recommended
pressure found on the tires.
Hitch Clip
Figure 42
Spacers
Wheel
Assembly
Support
Valve Stem
Protective Cap
Figure 43