DR Power 3-Point Hitch (April 2015 - Present) - Manual (Page 28)

7 5 M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1
©2015 Country Home Products, Inc. All rights reserved 364161
Daily Checklist for the DR 3-POINT HITCH TRIMMER/MOWER
To help maintain your DR 3-POINT HITCH TRIMMER/MOWER for optimum performance, we recommend you follow this checklist each
time you use your machine.
[ ] CUTTING CORDS: Replace broken or frayed Cords.
[ ] MOW-BALL® and Cord Head: Check the Mow-Ball® and Cord Head for wear and replace as needed.
[ ] GENERAL CONDITION: Check the general condition of the machine, e.g.; nuts, bolts, welds etc.
End of Season and Storage

Lubricate PTO Shaft Grease Fittings.
 Check the Drive Belt for wear. Replace as needed.

Release Drive Belt from Tensioner to relieve Belt stress.
 Check the general condition of the machine, e.g.; nuts, bolts, welds, etc. Replace parts or tighten Hardware as needed.

Store in a dry covered area to protect from moisture.
 Remove any wrapped weeds from the Mow-Ball® and Wheel Assembly. Clean grass and debris from the top and
underneath the Trimmer Frame.
Disengage PTO, shut down the Tractor Engine, remove the Key, wait for all moving parts to come to a complete stop, disconnect
the PTO shaft from the Tractor, then wait five minutes before performing any maintenance procedure or inspection on the
Trimmer.
Disengage PTO, shut down the Tractor Engine, remove the Key, wait for all moving parts to come to a complete stop, disconnect
the PTO shaft from the Tractor, then wait five minutes before performing any maintenance procedure or inspection on the
Trimmer.