DR Power Walk-Behind Pro (2000 - 2001) - Manual (Page 20)

DR
®
TRIMMER/MOWER
™
Assembly & Operating Instructions 14
Cord Installation
The standard cord installation method is shown in Figures 24-26. This is how your trimmer is
shipped from the factory.
1. Insert the ends of the cords into the
openings in the line plate, as shown in
Figures 23 and 24. There are different
sized arrows at the insertion points to
indicate what size cords fit the holes.
2. Push the cord through until it comes
out the center hole in the line plate as
shown in Figure 25. Adjust the cords
so the tips are even.
3. Pull the cords below the loop and push
the loop up into the groove above
them, as shown in Figure 26. Then
pull the cords tight.
Figure 24
Figure 25
Figure 26