DR Power Walk-Behind Pro (2000 - 2001) - Manual (Page 33)

DR
®
TRIMMER/MOWER
™
Assembly & Operating Instructions 27
To Replace the Belt
Figures 45 & 46 show the belt and pulley system from the underside of the machine.
WARNING! Before performing any
maintenance procedure, the engine
should be stopped and the spark plug
wire disconnected.
1. Remove the bearing housing assembly
(see page 25).
2. Remove the old belt.
3. Take the new belt and loop it over the
bearing housing pulley and in between
the pivot sleeve and belt guide (Figure
47).
4. Put the opposite end of the belt around
the engine pulley, making sure the belt
is INSIDE the belt retainer, on the
INSIDE of idler pulley #1 and on the
OUTSIDE of idler pulley #2 (Figure
45). Figure 45
Figure 46
Figure 47