DR Power Walk-Behind Pro (2000 - 2001) - Manual (Page 29)

DR
®
TRIMMER/MOWER
™
Assembly & Operating Instructions 23
To Reassemble the Mow-Ball
™
Support Assembly
WARNING! Before performing any maintenance procedure, the engine should be stopped
and the spark plug wire disconnected.
Caution: Improper installation may cause damage to the bearings. Please follow these
directions carefully.
1. Reassemble the components in the order shown in
Figure 37.
· The line plates stack on top of one another with
the bumps on the bottom locking into the grooves
on the top of each plate.
· The head of the Mow-Ball ™
bolt should sit in the
groove of the rectangular washer at the bottom of
the Mow-Ball
™
Support. Hold the bolt head in
place with one finger and turn the Mow-Ball
™
Support assembly clockwise until it's finger tight.
Figure 37