DR Power Dual Action 10-Ton Electric (Aug 2011 - Present) - Manual (Page 24)

24 DR ® DUAL-ACTION ELECTRIC LOG SPLITTER
Troubleshooting Table (Continued)
S YMPTOM P OSSIBLE C AUSE
Ram advances with a
jerky motion or with
strong vibrations.  Check the possible causes for the Ram operation symptom in “Log fails to split” above.
 Check the hydraulic fluid level.
 Bleed any accumulated air from the hydraulic system. To bleed, make sure the fluid level is
correct, cycle in one direction, bottom out, hold for 5 seconds, retract fully, bottom out, hold
for 5 seconds, repeat 10 times. If the problem persists, visit our website at
www.DRPower.com or call 1-800-DR-OWNER (376-9637) for assistance.
Hydraulic fluid leaking
from the ram or other
external parts.  The hydraulic fluid seals may be worn. Visit our website at www.DRPower.com or call 1-800-
DR-OWNER (376-9637), or call a qualified hydraulic mechanic for assistance to replace worn
components. Be sure to reference Hydraulic Safety in Chapter 1.
Splitter Breaker or house
Breaker is being tripped
excessively.  Pressure Valve set too high; Adjust Valve pressure by performing adjustment on page 18.
Before performing any repairs or maintenance procedure, unplug the Log Splitter power cord from the power source.