Brake cable adjustment, Changing the brake pads – DR Power Powerwolf Power Wagon User Manual
Page 31
DR
Powerwolf
Safety & Operating Instructions
25
Brake Cable Adjustment
Note:
The brake cable is factory set. If you think the brake cable needs to be adjusted, you
may actually need to replace the brake pads. See below.
Changing the Brake Pads
WARNING!
Before performing any maintenance procedure, set the
parking brake, stop the engine, and disconnect the spark plug wire.
Note:
If your DR Powerwolf rolls on slopes when the brake is set, and you have tried
adjusting the brake, the brake pads may need to be replaced.
Tools & Supplies Needed:
§ 1/2" wrench or socket
§ Mat or container for loose parts
Note:
You may want to remove the wheel to provide easier access to the brake area. (See
page 22)
1. Find a level area to work.
The parking brake should
NOT be engaged. Block the
wheels so the machine
cannot move.
2. Locate the brake caliper
at the right front of the
machine (Figure 17).
3. Use 1/2" wrench to
remove the two caliper
bolts holding the brake
caliper.
4. Remove the spring.
5. Carefully remove the
caliper.
Figure 17: Brake Assembly
Figure 18: Brake Disk – Caliper Removed
Caliper
Bolts
Spring
Brake
Disc
Brake
Caliper