Worcester actuation systems – Flowserve DFP17 User Manual
Page 25
WCAIM2037
DataFlo Digital Electronic Positioner DFP17 Installation, Operation and Maintenance Instructions
25
Figure 9
The following screen appears when the ICP program is first started:
The following screen appears after the Positioner Default Data is Loaded: (Some values may vary)
Flow Control
Worcester Actuation Systems
Security Code:
Unit Address:
Output Current Rng (mA):
Setpoint Direction
Split Range Start (%):
Split Range End (%):
Ramp Open Time (sec):
Ramp Close Time (sec):
Setpoint Function:
Dead Band:
Loss of Sig Position:
Loss fo Sig Time:
Power-on Position:
Power-on Time:
Lower Limit (%):
Upper Limit (%):
Tight Shutoff OK?:
Full Open OK?:
Brake ON Time (sec):
Run Cycles:
Deviation Alarm (sec):
Over-travel Alarm (%):
Under-travel Alarm (%):
Input:
PC Cmd:
Output:
Shaft Pos:
DB Run:
Over
Under
Dev
Therm
Open Time:
Close Time:
Cycle Time:
F2
-
Load File
F3
-
Save File
F4
-
Toggle Control
F9
-
Free Curve Edit
F10
-
Text Area Edit
F12
-
Change Position
↔
-
Dec/Inc Position
Alt-x
-
Exit Program
Comm Link:
Status
Alarms
Calibration Data
Ver. x.xx
Security Code:
XXXX
Unit Address:
1
Output Current Rng (mA):
4-20
Setpoint Direction:
RISE
Split Range Start (%):
0
Split Range End (%):
100
Ramp Open Time (sec):
0
Ramp Close Time (sec):
0
Setpoint Function:
LINEAR
Dead Band:
0.5
Loss of Sig Position:
0
Loss fo Sig Time:
0
Power-on Position:
0
Power-on Time:
0
Lower Limit (%):
0
Upper Limit (%):
100
Tight Shutoff OK?:
NO
Full Open OK?:
NO
Brake ON Time (sec):
0.25
Run Cycles:
0
Deviation Alarm (sec):
35
Over-travel Alarm (%):
100
Under-travel Alarm (%):
0
Input:
45.0%
PC Cmd:
50.0%
Output:
12.0 mA
Shaft Pos:
50.1%
DB Run:
0.5%
Over
Under
Dev
Therm
Open Time:
25s
Close Time:
25s
Cycle Time:
50s
F2
-
Load File
F3
-
Save File
F4
-
Toggle Control
F9
-
Free Curve Edit
F10
-
Text Area Edit
F12
-
Change Position
↔
-
Dec/Inc Position
Alt-x
-
Exit Program
Comm Link: CONNECTED
Status
Alarms
Calibration Data
Ver. x.xx