Fronius Acctiva Professional Flash - Manual (Page 56)

54
User charging
mode User charging is an additional charging mode in which charging parameters for the device
can be specified individually.
The parameters for user charging mode are preset in the factory for standby applications
(e.g. emergency power systems) or for ambient temperatures > 35° C (95° F).
The user charging mode should be used for:
-
charging / conservation charging with battery either fitted or removed
- trickle mode (to charge the battery when consumers in the vehicle are switched on)
External power
supply mode The external power supply mode is to ensure consumers have a power supply
-
when there is increased power consumption (e.g. updating firmware/software for the
vehicle’s electronics),
- in back-up mode, to supply power to the on-board electronic systems while the battery
is being changed (to avoid losing settings such as time, radio settings, etc.).
Charge accept-
ance test mode Charge acceptance test mode is used to test a battery’s ability to accept a charge. The test
takes place as follows:
-
the automatic charge acceptance test takes only a few minutes
- the charge acceptance test is ended after a predefined period has elapsed
- if the result is positive, the device will switch automatically to standard charging mode
and charge the battery
- if the result is negative, „Test Fail“ appears on the charger’s screen and charging of
the battery is halted.