Fronius Selectiva - Manual (Page 24)

22
Setup menu
General
In the Setup menu, select the characteristic type according to the battery to be charged, or
the requirement shown in the accompanying characteristic data sheet (normal charging,
back-up mode, reactivating deep-discharge batteries, buffering).
Accessing the
Setup menu
Connect mains cable to charger and plug into mains
Charger is on standby - ready indicator is lit
Press and hold the Start/Stop button for approx. 10 seconds to call up the Setup menu
Ready indicator goes out. The charger is in Setup mode. The display also shows the
selected characteristic type
Selecting the
characteristic
type Press the Start/Stop button to select the characteristic type according to the enclosed
characteristic data sheet
If there is no further selection within 10 seconds, the selected characteristic type is
saved.
Ready indicator lights up. Once the new characteristic type has been selected, the
charger is automatically ready for the next charging sequence.
NOTE! The following section only applies to the standard control panel (LED ver-
sion).
NOTE! Do not connect the charger lead to the battery. If the charging terminals
are connected, no characteristic type can be selected.
1
2
3
4
NOTE! Do not connect a battery during these 10 seconds.
Continue as described in the "Charging the battery" section.
1
2
4