FSR WB-X1-GNG - Manual (Page 2)

2.
INSTALL CHASSIS INTO WALL PER
INSTRUCTIONS AT THE END OF THIS
DOCUMENT.
MAKE ELECTRICAL CONNECTIONS AS REQUIRED.
INSTALL FRAME ASSEMBLY AS SHOWN IN
FIGURE 4.
3.
STEPS:
1.
5. INSTALL IPS WALLBOX BUCKETS AS SHOWN IN
FIGURE 5.
6.
4.
ASSEMBLE FRAME ASSEMBLY AS SHOWN IN
FIGURE 3.
ROUTE CONDUITS TO CHASSIS, AND PULL
WIRES AS REQUIRED.
(4) #8-32x1/4" FLAT HEAD SCREW
(LOCTITE RECOMMENDED)
NOTE SLOT
IPS UPPER INTERIOR
SUPPORT BRACKET
IPS LOWER INTERIOR
SUPPORT BRACKET
(2) IPS BUCKET
MOUNTING BRACKET
NOTE SLOT LOCATION,
WHICH DESIGNATES
UPPER END OF CHASSIS
UPON INSTALLATION
(6) #8-32x1/4" FLAT
HEAD SCREW
CHASSIS ASSEMBLY
(AVAILABLE WITHOUT KO'S)
FRAME
ASSEMBLY
(8) #8-32x1/4" FLAT
HEAD SCREW
(2) IPS WALLBOX
BUCKET
UPPER END OF
CHASSIS UPON
INSTALLATION
WB-X1-IPS
NOTE: ASSEMBLE
FRAME AS SHOWN ON
A FLAT SURFACE
FIGURE 3
FIGURE 4 FIGURE 5