FSR WB-X1-GNG - Manual (Page 3)

HEIGHT ADJUSTMENT HOLE
(ENSURE BOTH BRACKET ASSEMBLIES
ARE USING THE SAME HOLES)
BLANK PLATE MOUNTING BRACKET
(2) #8-32x3/8" PAN
HEAD SCREW
MOUNTING
BRACKET
SUPPORT
(6) #8-32x1/4" FLAT
HEAD SCREW
BRACKET ASSEMBLY
BRACKET
ASSEMBLY
CHASSIS ASSEMBLY
(AVAILABLE WITHOUT KO'S)
(4) #8-32x3/8" PAN
HEAD SCREW
BLANK PLATE
INSTALL BRACKET ASSEMBLIES AS SHOWN IN FIGURE 7.
MAKE ELECTRICAL CONNECTIONS AS REQUIRED.
INSTALL CHASSIS INTO WALL PER INSTRUCTIONS AT THE END
OF THIS DOCUMENT.
6.
3.
ROUTE CONDUITS TO CHASSIS, AND PULL WIRES AS REQUIRED.
STEPS:
5. MODIFY BLANK PLATE AS NECESSARY TO MOUNT DESIRED
COMPONENTS. INSTALL THIS PLATE AS SHOWN IN FIGURE 8.
ASSEMBLE BRACKET ASSEMBLY AS SHOWN IN FIGURE 6.
4.
2.
1.
WB-X1-PLT
FIGURE 6
FIGURE 7 FIGURE 8
COMPONENT AREA