Gasboy 9800 Rear Totalizer Kit - Manual

C35626 Rev. 8008 Page 1
INSTRUCTIONS FOR REAR TOTALIZER KIT, C06818
Locate and identify the following parts from the Totalizer Kit. Hardware and quantities may vary.
QTY PART NO. DESCRIPTION
1 C06819 Cable Assy., Rear Totalizer
2 053625 Screw, #6-32 x 3/8 TT
2 053737 Screw, #8-32 x 3/8 TT
1. Installing this kit involves DC wiring to the fuel management system. Read Sections 3 and 4 of the Pump/Dispenser
Installation Manual and your fuel management system Installation Manual before proceeding.
2. Turn off the circuit breakers supplying power to the MICRO, LIGHTS and FEED.
3. Unlock and remove the front panel.
4. Remove the two bolts located over the tabs of the bezel assembly. Lift the bezel
assembly upwards and out to remove.
5. Loosen, and remove if necessary, two screws located on the left and right door
support brackets and pivot the display panel down.
6. Pull the connector off P1 (a) on the
power supply. After a few seconds,
reconnect P1.