Gasboy 8700K - Manual

MDE-4512A Lamp Kit (M06227K00X) Installation Instructions for Atlas® 8700K/9100K and 8800K/9800K · June 2014 Page 1
Introduction
Purpose
This manual provides instructions to install the Lamp Kit (M06227K00X) on the following
Atlas
® pumps/dispensers:
• Models 8700K/9100K (Mechanical) - M06227K001 Kit
• Models 8800K/9800K (Electronic) - M06227K002 Kit
Required Reading
Before installing the kit, review and follow:
• National Fire Protection Association (NFPA) 30A and the Automotive and Marine Service
Station Code.
• NFPA 70 ® and The National Electrical Code (NEC ® ).
• Applicable federal, state, and local codes and regulations.
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: These kits must be installed by a Gasboy ® Authorized Service Contractor (ASC) to
ensure warranty.
Table of Contents
Topic Page
Introduction 1
Important Safety Information 4
Before You Begin 6
Preparing for Installation 6
Installing Lamp Kit (M06227K00X) 7
Completing Installation 13
Required Tools and Materials
Following tools and materials are required to install the Lamp Kit:
• Open-end Wrench Set
• Phillips
® and Flat-blade Screwdrivers
• Pair of Pliers
• Wire Cutter/Stripper
MDE-4512A
Lamp Kit (M06227K00X) Installation Instructions for
Atlas ® 8700K/9100K and 8800K/9800K
June 2014