Gasboy External Filter - Manual

MDE-4528A Gasboy® External Filter Kit Installation Instructions · November 2007 Page 1
Introduction
Purpose
This manual provides instructions for the installation of an External Filter option. Depending
on the type of filters installed, this option will provide protection against particulates and
water. The adapter in this kit incorporates a special groove design that is required when used
with a blue cold weather gasket.
This kit contains parts for the following models.
Kit Number Filter Type Pump Model
032753 Hydro (particulate and water)
216A, 9510 and 9850A
032752 Standard (particulate only)
Table of Contents
Topic Page
Introduction 1
Important Safety Information 3
Installation of the Kit 5
Required Tools
The following tools are required for the installation of the kit:
• Two pipe wrenches
• UL
® -classified gas and oil resistant pipe compound
Required Reading
The installer must read and understand all instructions, safety warnings and precautions before
beginning. The installer must also be familiar with:
• This manual
• NFPA 30A, The Automotive and Marine Service Station Code
• NFPA 70, The National Electric Code
• Applicable Federal, State and Local codes and regulations
Failure to do so may adversely affect the safe use and operation of the equipment.
Note: This kit must be installed by a Gasboy Authorized Service Contractor (ASC) to ensure
warranty.
MDE-4528A
Gasboy ® External Filter Kit
Installation Instructions
November 2007