Gasboy C01533 - Manual

C35799 Rev. 04/25/03 Page 1
MODEM SETUP INSTRUCTIONS FOR C01533 AND C05899 MODEMS
This packet contains modem setup information for both the C01533 PC Package/Answer Modem and the C05899
Credit/Debit Card Network Modem. Be sure to use the correct modem and instructions for your application. WARNING:
Network applications must use C05899 modems only. Gasboy will NOT pay warranty claims for C01533 modems
which are used for network applications.
SETUP INSTRUCTIONS FOR C01533 – PC PACKAGE/ANSWER MODEM
The modem already comes factory-programmed with the correct command strings and you should typically never need to
perform this configuration.
The C01533 PC Package/Answer Modem is identified by the following manufacturers and model numbers:
•
Zoom Faxmodem 56Kx Dualmode (white case)– Models 2948L, 2949L
•
Zoom V.90 Faxmodem (black case): Model 2948C
•
Hayes Accura – Model 5611US, 5914US, or 4703US
•
Boca Research – Model MV34ED, MV34FEMS, M144EW, or MD56AE
•
Practical Peripherals – Model 5615US or 5638US
Configuring for use as a PC Package/Answer Modem
•
If this modem is to be connected directly to your PC for use with GASBOY PC software, disregard this setup sheet and
refer to your PC software manual for the appropriate modem initialization strings.
•
If this modem is connected to a CFN system, use the diskette supplied with the modem to run the configuration utility,
PROGMODM.CMD. Insert the diskette into the A: drive and type A:PROGMODM. Follow the instructions in
PROGMODM for configuring as an answer modem.
•
If you do not have the diskette containing the PROGMODM.CMD utility, or if the modem will connect to a Series 1000 or
TopKAT system, follow the procedure below. The
↵
symbol means press the ENTER key and the 0’s are zeros, not the
letter O.
1. Connect a terminal to the modem with a 1:1 cable male DB-25 to male DB-25 (C04549) or male DB-25 to female
DB-9 (C04654). The terminal must be configured at the baud rate at which the modem will operate.
2. Connect the modem’s power cord and turn the modem power switch ON.
3. For Zoom Model 2948C (V.90 Faxmodem, black case), enter the following:
Type: AT&F&W
↵ ↵
Modem response: OK.
Type: AT&D2S0=1&C1&Q6X0&K0+MS=nnnn
↵ ↵
NOTE: nnnn is a baud rate variable. Valid values are: V22 for 1200 baud, V22B for 2400 baud, or V32 for
9600 baud.
Modem response: OK.
Type: ATQ1&W
↵ ↵
Modem does not respond.
For all other modem types enter the following:
Type: AT&F&W
↵ ↵
Modem response: OK.
Type: AT&D2S0=1&C1B1&Q6X0&K0&W
↵ ↵
Modem response: OK.
Type: ATQ1&W
↵ ↵
Modem does not respond.
The modem is now ready for testing. The settings are saved and power may be turned off without losing the configuration.
See next page for C05899 Modem Setup