Gasboy DLL2020 Scanner - Manual

MDE-4389A Setting Up Datalogic DLL2020 Bar Code Scanner Used on Profit Point Terminal • September 2005 Page 1
Introduction
If you have a Polaris bar code scanner, refer to C35424 Setting Up Your Polaris Bar Code
Scanner.
Your bar code scanner has been programmed at the factory and should be ready to operate.
This document contains a verification sequence that allows you to determine whether your
scanner is programmed correctly, and a programming sequence to follow if it is not
programmed correctly.
Setting Up the Scanner
1 Turn off power to the Profit Point point of sale (POS) terminal.
2 Unplug the AC power to the POS distribution box power supply.
3 Connect the 9-pin RS-232 end of the terminal interface cable to the 9-pin connector on the
scanner.
4 Connect the other end of the terminal interface cable to the SCANNER port on the POS
distribution box and plug in the POS distribution power supply.
5 Turn on the Profit Point POS terminal.
When you turn on the power to the Profit Point, follow the instructions on the screen. The
Profit Point will then initialize and begin Point-of-Sale operations.
Performing Verification Sequence
While in Point-of-Sale operations, scan an item. The scanner should beep when the item is
scanned.
• If the correct item description appears on the screen, the scanner is programmed correctly.
• If the message “# not on file” appears and the number shown on the screen matches the
number under the scanned bar code, the scanner is functioning correctly, but the bar code
cannot be identified. The display may not show the first or the last digit printed on the
item. Press CLEAR MENU to cancel the item entry.
• If the screen does nothing or displays” Data Error on Scanner Port” or “Item Entry Error,”
repeat the scan. If the same message displays, the scanner may be programmed
incorrectly. Proceed with
“Programming Sequence” on page 2 .
Note: The first time the scanner is turned on, the first scan may produce the error message
“Data Error on Scanner Port” even if the scanner is programmed correctly.
MDE-4389A
Setting Up Datalogic DLL2020 Bar Code
Scanner Used on Profit Point Terminal
September 2005