Gasboy C01533 - Manual

MDE-4892 C01533 and C05899 Modems Setup Instructions · February 2010 Page 1
Purpose
This document provides modem setup instructions for the C01533 PC Package/Answer Modem and C05899
Credit/Debit Card Network Modem.
Only C05899 modems must be used for Network Applications. Gasboy ® will NOT pay warranty
claims for C01533 modems that are used for network applications.
IMPORTANT INFORMATION
Setup Instructions for C01533 - PC Package/Answer Modem
Note: The modem is factory-programmed with the correct command strings. You typically do not have to perform this
configuration.
The C01533 PC Package/Answer Modem is identified by the following manufacturers and model numbers:
Manufacturers Model Numbers
Zoom ® Faxmodem 56Kx Dual mode (white case) 2948L, 2949L
Zoom V.90 Faxmodem (black case) 2948C
Hayes Accura ® 5611US, 5914US,
4703US
Boca Research ® MV34ED, MV34FEMS,
M144EW, MD56AE
Practical Peripherals ® 5615US, 5638US
MultiTech ® MT5656ZDX
Configuring for use as a PC Package/Answer Modem
• If this modem is connected directly to your PC for use with Gasboy PC software, disregard the instructions
provided below and refer to your PC software manual for the appropriate modem initialization strings.
• If this modem is connected to a CFN system, use the disk supplied with the modem to run the configuration utility,
PROGMODM.CMD. Insert the disk into the A: drive and type A:PROGMODM. Follow the instructions in
PROGMODM for configuring as an Answer modem.
• If you do not have the disk containing the PROGMODM.CMD utility, or if the modem can be connected to a
Series 1000 or TopKAT ™ system, proceed as follows to configure the modem:
Note: The

symbol denotes Enter key and the 0s are zeros, not the letter O.
1 Connect a terminal to the modem with a 1:1 cable male DB-25 to male DB-25 (C04549) or male DB-25 to
female DB-9 (Q13204-09). The terminal must be configured at the baud rate at which the modem will operate.
2 Connect the modem’s power cord and turn ON the modem power switch.
3
Manufacturers Type Modem Response
Zoom Model 2948C (V.90 Faxmodem, black
case) or MultiTech Model MT5656ZDX
AT&F&W

OK
AT&D2S0=1&C1&Q6X0&K0+MS=nnnn

OK
ATQ1&W

Modem will not respond
Note: nnnn is a baud rate variable. Valid values are: V22 for 1200 baud, V22B for 2400 baud, or V32 for 9600 baud.
Other modem types
AT&F&W

OK
AT&D2S0=1&C1B1&Q6X0&K0&W

OK
ATQ1&W
 Modem will not respond
Perform the commands for the specific modem as listed in the following table:
The modem is now ready for testing. The settings are saved and the configuration is not lost when the power is turned
off.
Setup Instructions for C05899 - Credit/Debit Network Modem is provided on page 2.
MDE-4892
C01533 and C05899 Modems Setup Instructions
February 2010