Gasboy Fuel Point Dispenser - Manual (Page 13)

Getting Started
03/28/03 2-3
DISPENSER RETROFIT J-BOX ASSEMBLIES
For Fuel Point, each pump or dispenser will require at least one J-Box/Amplifier Assembly and
one Hose Retrofit Kit for each hose outlet from the list below.
J-Box/Amplifier Assembly
C06832 One
Hose
C06833 Two Hose
UNPACKING THE DISPENSER RETROFIT KIT
The contents of the hose modification kit portion of the dispenser retrofit kit is broken down on the
following two pages. You will need the following tools to complete this installation:
•
pipe wrenches
•
screwdrivers
•
meter
•
small crescent wrench
•
electrical tape
•
electrician’s snake or pull wire
•
scissors
•
ruler
•
UL-classified pipe thread sealant
•
O-Ring lubricant (Parker O-Lube or
equivalent)
•
6" Heavy-duty tapered Head Cutters
Pliers (Klein, #490PL108)
• Automatic Single Squeeze wire stripper
(Stripmaster, #462ST028)
• channel lock pliers
•
special clamp pincer tool
for VR and VA nozzles
• Crimp tool with crimp
mechanism in head, not in
handle, (T&B #WT-111 or
Klein #490ST016)