Gasboy Fuel Point Ground Antenna - Manual (Page 12)

Component Overview Required Components
Page 8 MDE-4530 Fuel Point Ground Antenna Installation Instructions · November 2005
Figure 2-2 Flush Mount Antenna Kit
• For a Direct Buried application, use antenna sealant (C09716). Sealant is normally used
at existing sites where little pavement construction is anticipated and surface or flush
mounting is not an option. The sealant is easy-to mix, two-part epoxy, and is fast curing.
One gallon is sufficient for sealing approximately four single ground antennas.
Figure 2-3 Antenna Sealant
• For a Surface Mounted application, use Surface Mount Antenna Kit (C07364). A surface
mounted antenna provides a visual indication for the antenna location and easy access to
the antenna. The surface mount housing is lightweight Traffic Yellow composite plastic
measuring 6 feet X 10 inches x 2 inches high. It is maintenance-free and durable, designed
to mount the antenna kits (C07362). The housing can be field drilled, or sawed for special
applications. It is furnished with housing mounting hardware for mounting to concrete
pavement. An optional kit (C07365) is available for mounting to macadam.
Figure 2-4 Surface Mount Antenna Kit
Fuel Point Gate Vehicle Components
Vehicle components required for ground loop communications are the same for both fueling
and gate control applications: a VM with gate circuitry, and a G-Ring. See C35699 Fuel Point
Vehicle Module Installation Manual for details.