Overview of the edit menu, Ed it m e nu, Piano, e.piano, sub parameters – Kawai MP10 User Manual

Page 34: Midi parameters

Advertising
background image

34

E

D

IT

M

e

nu

Overview of the EDIT Menu

The EDIT menu contains various parameters that can be used to adjust the MP10's sound and MIDI sections. The

parameters are grouped by category, allowing close control over the instrument with just a few button presses.

This collection of parameters, together with other adjustable settings, can be stored as a SETUP memory (page 50).

The MP10 provides 26 banks x 6 setups, for a total of 156 user programmable setup memories.

„ PIANO, E.PIANO, SUB parameters

Page No.

Category

Parameters

1

REVERB

Type, Pre Delay, Time, Depth

2

EFX

Type, Parameters

(depends on EFX type)

3

VirtTech

(PIANO)

Voicing, Stereo Width, String Resonance, Damper Resonance, Key-off Effect,

Damper Noise, Hammer Delay, Fall Back Noise, Brilliance

AMP

(E.PIANO)

Amp Type, Drive, Level, Amp EQ

Layer

(SUB)

Sweep, Bell

4

Tuning

Fine Tune, Stretch Tuning, Temperament, Key of Temperament

5

KeySetup

Touch Curve, Octave Shift, KS-Damping/KS-Key, Split/Split Point,

Key Off Noise

(E.PIANO)

, Key Off Delay

(E.PIANO)

, Dynamics

(SUB)

6

Control

Damper Pedal, Damper Pedal Mode, Left Pedal, Left Pedal Assign, Pitch Bend,

Bend Range, Modulation Wheel, Modulation Wheel Assign, Expression Pedal,

Expression Pedal Assign, Foot SW, Foot SW Assign

7

KnobAsgn

n/a

8

Sound

Attack Time, Decay Time, Sustain Level, Release Time, Filter Resonance,

Filter Cut-Off, Panpot, Volume

Unless stated, parameter settings for the PIANO, E.PIANO, and SUB sound sections are independent for each section.

Parameters marked with a icon are common for all three sections.

„ MIDI parameters

Page No.

Category

Parameters

1

Program

Program, Bank MSB/LSB

2

Transmit

(SYSTEM)

Send Program, Send Bank, Send Volume, Send Knobs, Transmitting Recorder

3

Receive

(SYSTEM)

Recieve Mode, PIANO Channel, E.PIANO Channel, SUB Channel

4

MMC

(SYSTEM)

MMC Dev. ID, MMC Commands

5

KeySetup

Touch Curve, Octave Shift, Split/Split Point, Dynamics, Solo, Transmit

6

Control

Damper Pedal, Left Pedal, Left Pedal Assign, Pitch Bend,

Bend Range, Modulation Wheel, Modulation Wheel Assign, Expression Pedal,

Expression Pedal Assign, Foot SW, Foot SW Assign

7

KnobAsgn

n/a

Parameters for the MIDI section marked with a

icon are SYSTEM parameters and memorised automatically.

Advertising