LSC Lighting Redback Operators Manual - Manual (Page 20)

Advanced Menu Redback Dimmer
Operator Manual V1.1
Page 18 LSC Lighting Systems (Aust) Pty. Ltd
1 2 C h
The 3 Flip key initiates the mode change
process and checks for confirmation:
6 C h ? N
The Up and Down † arrow keys toggle
between Y and N.
If the confirmation is set to Y, pressing the
3
Flip key changes channel mode then triggers a
Total Reset.
w a i t . .
6.15 Resetting Redback
R E S E T
The Reset menu provides two levels of reset.
6.15.1 System Reset (SYSRST)
Shuts down and restarts (reboots) the Redback.
All levels and memories are retained and
restored after system restart. This is the
equivalent of switching the power to Redback
off, then on again.
6.15.2 Total Reset (TOTRST)
Shuts down Redback and sets all parameters
(addresses, curves, scenes, times, minimum
and maximum levels, etc) back to their default
values, then restarts. The 6 channel or 12
channel Set-Up is retained during this reset.
The Right
„ arrow key activates the Reset
menu.
In this screen:
The
ƒ Left and Right „ arrow keys toggle
between System Reset (SYSRST) and Total
Reset (TOTRST).
The
3 Flip key initiates the reset process and
checks for confirmation:
S U R E ? N
The Up and Down † arrow keys toggle
between Y and N.
If the confirmation is set to Y, pressing the
3
Flip key triggers the reset process.
w a i t . .
Warning:
A Total Reset, sets all dimmers to the default S
law curve (SCU). This could potentially result in
240 Volts being fed to 120 Volt lamps.
Note: A total Reset can also be performed by
holding down
Up and Down † buttons whilst
turning on power to the dimmer. This method is
particularly useful if you have forgotten the
LOCK password.