LSC Lighting Redback Operators Manual - Manual (Page 24)

Company Profile Redback Dimmer
Operator Manual V1.2
Page 22 LSC Lighting Systems (Aust) Pty. Ltd
1 0 S o f t w a r e ( F i r m w a r e ) U p g r a d e s
LSC Lighting Systems has a corporate policy of continuous improvement to its products. Redback's
firmware (internal software) is subject to this policy as new features are added and existing features
improved.
The software version of your Redback is momentarily displayed on the LCD screen at power up and on
the ABOUT option screen in the Advanced Menu system. The latest version of Redback software can be
downloaded from the LSC web site,
www.lsclighting.com/help-centre/downloads
10.1 Upgrading Redback's Firmware
Upgrading the firmware resets all parameters (addresses, curves, scenes, times, minimum and maximum
levels, etc) back to their default values.
To upgrade the firmware:
• Check the current release number from the ABOUT screen in the Advanced Menu system.
• Check that a newer version is available from the Downloads area at the LSC Lighting Systems
web site www.lsclighting.com/help-centre/downloads .
• Download the new firmware file.
• Unpack
both .prg files from the downloaded archive and copy it into the top level (root)
directory of a 2GB or smaller SD flash memory card. Do not rename the files.
• Insert the SD flash card into the slot on the front panel of the dimmer.
• Power
up the Redback while holding down both the red Menu Up S and Menu Down T keys.
• The display flashes and counts through a file checksum up to CS 100% then the program data
up to PG 100%
• Redback then reboots and displays the new firmware release version before continuing with
normal operation.
1 1 C o m p l i a n c e S t a t e m e n t s
11.1 C Tick Compliance Statement
All LSC products with CE Compliance automatically comply with C-Tick requirements as per Section 182
of the Radiocommunications Act 1992. LSC Company Registration number is N921.
11.2 CE Compliance Statement
The Redback Dimmer from LSC Lighting Systems (Aust) Pty. Ltd. has been designed and tested to the
European Committee for Electrotechnical Standardization (CENELEC) standard– EN55022 (Information
Technology Equipment).
11.3 Product of Australia
The Redback dimmer meets the requirement status “Product of Australia” as defined by the Australian
Governments Trade Practise Act 1974, Section 65AC and administered by the Australian Made
Campaign Limited (AMCL). All LSC manufactured products have virtually all of their design, production
and manufacture processes occur in Australia, thus qualifying for the highest status by the AMCL.
11.4 Disclaimer
LSC Lighting Systems (Aust) Pty. Ltd. has a corporate policy of continuous improvement, covering areas
such as product design and documentation. In light of this policy, some detail contained in this manual
may not match the exact operation of your product.
In any event, LSC Lighting Systems (Aust) Pty. Ltd. can not be held liable for any direct, indirect, special,
incidental, or consequential damages or loss whatsoever (including, without limitation, damages for loss
of profits, business interruption, or other pecuniary loss) arising out the use or the inability to use this
product for its intended purpose as expressed by the manufacturer and in conjunction with this operating
manual.
Servicing of this product is recommended to be carried out by LSC Lighting Systems (Aust) Pty. Ltd. or its
authorised service agents. No liability will be accepted whatsoever for any loss or damage caused by
service, maintenance or repair by unauthorised personnel. In addition servicing by unauthorised
personnel may void your warranty.