Marantz NR1501 - Manual (Page 18)

NAMES AND FUNCTIONS
14
BASIC
CONNECTIONS
BASIC
OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
BASIC
OPERA
TION
ENGLISH
TUNER OPERATION
To operate the unit from the remote controller, press
the TUNE button on the remote controller so that
the tuner mode is engaged.
LISTENING TO THE TUNER
Frequency scan step for AM is selectable.
1. 2. 3.
1.
Default setup is 10 kHz step, if your country’s
standard is 9 kHz step.
Press BAND button on the front panel.
• “AM 10 kHz” appears on the display.
2. Press the 1 or 2 cursor buttons on the front
panel.
• “AM 9 kHz” appears on the display, and
the tuning increment is switched to 9
kHz.
3. Press ENTER button on the front panel.
Note
• Preset memory for the tuner will clear by changing
this setup.
AUTO TUNING
1. 2. 3.
1.
3.
2.
(Using the unit)
1.
Turn the INPUT SELECTOR knob to select
“TUNER”.
2. Press the BAND button to select either FM
or AM.
3. Press the 3 or 4 cursor buttons on the front
panel for more than 0.5 second to start the
auto tuning function.
4.
Automatic searching begins then stops
when a station is tuned in.
(Using the remote controller)
1.
To select tuner, press the TUNE button
twice within two second on the remote
controller.
2.
Press the BAND button to select either FM
or AM.
3.
Press and hold the TUNE 3 or 4 button for
0.5 second or more.
4.
Automatic searching begins then stops
when a station is tuned in.
If tuning does not stop at the desired station, use to
the “Manual tuning” operation.
MANUAL TUNING
1. 2. 3.
1.
3.
2.
(Using the unit)
1. Turn the INPUT SELECTOR knob to select
“TUNER”.
2. Press the BAND button to select either FM
or AM.
3.
Press the 3 or 4 cursor buttons on the front
panel to select the desired station.
(Using the remote controller)
1.
To select tuner, press the TUNE button
twice within two seconds on the remote
controller.
2.
Press the BAND button to select either FM
or AM.
3.
Press the TUNE 3 or 4 button to tune in the
deseired station.
BASIC OPERATION
SWITCHING THE FM MODE
FM broadcasts are usually received in stereo,
but when the quality of the signals received from
a station that broadcasts programs in stereo is
poor, the amount of accompanying noise may be
signifi cant.
In a case like this, by selecting the FM monaural
mode, the level of the noise will be reduced, making
it more pleasant to listen to the FM program.
1. When the T.MODE button on the remote
controller is pressed during FM reception,
the ST indicator on the display goes off,
and the FM monaural mode is established.
2.
When the T.MODE button is pressed again,
the ST indicator illuminates, and the stereo
mode is restored.