Microcom 814M Programming Manual - Manual (Page 14)

10
Bit Off/On Hex. Description
0 0/1 00/01 PRST without paper / PRST with paper
1-3 0 00 Fixed to 0
4 1 02 Fixed to 1
5-7 0 00 Fixed to 0
n = 10, reset printer
ƒ Printer shall clear error information and buffer area and execute half-auto feeding.
n = 11, clear printer error
ƒ When executing this command, the printer shall clear errors automatically according to error
status. If the operation succeeds, it enters normal status, otherwise only via manual
operation.
CAN
[Name]
[Format]
[Description]
[Notes]
[Reference]
Cancel print data in page mode
ASCII CAN
Hex 18
Decimal 24
In page mode, deletes all print data in the print buffer.
ƒ This command is enabled only in page mode.
ƒ If data that existed in the previously specified printing area also exists in the currently
specified printing area, it is deleted.
ESC L, ESC W
ESC FF
[Name]
[Format]
[Description]
[Notes]
[Reference]
Print data in page mode
ASCII ESC FF
Hex 1B 0C
Decimal 27 12
In page mode, prints all buffered data in the printing area collectively.
ƒ This command is enabled only in page mode.
ƒ After printing, the printer does not clear the buffered data, does not change the
settings for ESC T and ESC W, and does not change the position for buffering
character data.
FF, ESC L, ESC S