Microcom 814M Programming Manual - Manual (Page 77)

73
4.2.2 Paper supported
Black mark paper is thermal sensitive paper on which black marks are published regularly. The black
marks are referenced to set print area and cut position. Refer to relative user’s manual for detailed black
mark requirements.
Examples:
1B 63 30 02 (select black mark paper)
1D 0C (move the next label to print position) 33 33 33 33 42 6C 61 63 6B 20 4D 61 72 6B 20
50 61 70 65 72
0A (print)
1D 56 00 (cut paper)
Printout：3333Black Mark Paper
Continuous paper is normal thermal sensitive paper rolls which is not used for fixing position.
Examples:
1B 63 30 00 (select continuous paper) 33 33 33 33 20 53 65 72 69 65 73 20 50 61 70 65 72
0A (print)
1D 56 00 (cut paper)
Printout: 3333 Series Paper
4.2.3 PRST action modes
Refer to commands 1B 63 38 n and 1B 63 39 n for detailed information.
If the PRST is enabled, the PRST will startup to hold the front end of printed paper during printing and
accommodate the printed paper. When the printing is finished and the paper is cut, the PRST hands out
the printout by holding the back-end of printed paper and waits for a specified time for the user to take
it away. After the waiting time, the PRST will
a) In retraction mode, retract the printout into a waste-bin to avoid environmental pollution and keep
secret of user-specified information in case the user do not take away the printout within limited time.
b) In ejection mode, discharge the printout to enable the next print (customized model).
c) In waiting mode, wait until the user takes the printout away and discharge it before next printing starts.
If the PRST is disabled, the PRST has no action during printing or after printing. With this selection, the
PRST part is disassembled to avoid paper jam.
Examples:
1) Select continuous paper, standard mode, PRST retraction mode and print.
0A (Set the print starting position to the beginning of the line)
1B 40 (initialize printer)
1B 63 30 00 (select continuous paper)
1B 63 39 04 (set PRST waiting time)