Microcom 814M Programming Manual - Manual (Page 66)

62
1) Daabbcc,
D：Linking structure mode, input particular identifier “D”, this mode is selectable. If this mode is
selected, the rest three parameters and separate symbol should be specified.
aa: The position of particular symbol, input 2 bit numbers in hex.
bb: The sum of symbol, input 2 bit numbers in hex.
Cc: Even or odd data, input 2 bit numbers in hex.
It is a fixed separate symbol
2) E: Error correction class. Range: L, M, Q, H, the correction class increases in turn.
3) M: Mask figure reference, Range: Default is automatic mask.
4) M: Data input mode, Range: A or M, A means automatic mode (recommended mode), M means
manual mode; If A mode is specified, you don’t need specify the character mode; If M mode is
specified, you must specify the character mode. Default mode is automaitic mode.
5) <Character mode><DATA1>,
<Character mode><DATA2>,
<Character mode><DATA3>,
……………………….
<Character mode ><DATAn>
Note: n>=200
Character input mode<N, A, B, K>
N: Number (0~9)
A: Number and alphabet mixed (0~9)(A~Z)(SP,$,%,*,+,-,.,/,:)
Bxxxx: 8 bit as a byte (0x00~0xFF)
K: Katakana
The legal bar width: The ratio of wide and narrow bar can not be adjusted.
Fox example:
1D 6B 0B 51 41 2C 30 31 32 33 34 35 36 37 38 39 41 42 43 44 20 32 44 20 63 6F 64 65 00
(Recommend automatic mode, the data mode symbol A can be omitted)
1D 6B 4c 12 48 4D 2C 4E 31 32 33 34 35 36 37 38 39 31 32 33 34 35
1D 6B 0B 4D 4D 2C 41 41 43 2D 34 32 00
1D 6B 0B 4C 4D 2C 4E 30 31 32 33 34 35 36 37 38 39 30 31 32 33 34 35 2C 41 41 42 43 2C
42 30 30 30 36 71 72 63 6F 64 65 00
1D 6B 0B 46 2C 4C 4D 2C 4E 30 31 32 33 34 35 36 37 38 39 2C 41 31 32 41 41 42 42 2C
42 30 30 30 36 71 72 63 6F 64 65 00
▪ When selecting MAXICODE barcode, the length of d1...d k (d1…dn) is not beyond the 84
characters, it consists of five parts, the format is as following:
1) 5 numbers of basic post code;
2) 4 numbers of the second post code;
3) 3 numbers of nation code;
4) 3 numbers of service class;
5) Character string.