NavCom SF-2050 Rev.D - Manual (Page 22)

SF-2050 User Guide - Rev. D
To power the unit on or off, the on/off (I/O) switch
must be depressed for more than 3 seconds. During
power up of the
GPS sensor, all LEDs will be on for a
period of 3-5 seconds.
„
Link LEDs
‡
The Link lights are software configurable via the
appropriate NavCom proprietary command. Because of
the numerous scenarios available for the Link light, only
the factory default configuration [Rover Mode] is
discussed.
LINK Status
Command Mode
Repeating Red to Amber to Green indicates
Searching
StarFire
™ signal
Strong Signal Strength from StarFire
™
Medium Signal Strength StarFire
™
Weak Signal Strength StarFire
™
Table 3: Link Light Indication
2-20