NavCom RT-3010 Rev.E - Manual (Page 27)

RT-3010 User Guide - Rev. E
pole, or any apparatus that accepts the thread size, as
seen in Figure 2.
Communications Ports
Connect the supplied LEMO 7-Pin end of the NavCom
serial cable (NavCom P/N 94-310090-3003) to COM 2
(factory default Control Port) connector of the RT-3010.
Connect the
DB9S end to your controlling device. Note
that some devices may require an additional adaptor, as
the receiver is configured as a DCE device.
‡
By factory default COM 2 is the control port for
the RT-3010. COM 1 can be designated as the
control port by using the appropriate NavCom
proprietary commands . NOTE: Some output data
types, such as NMEA messages, cannot output on the
Control Port.
Figure 6: Communications Port Interface
3-25