Onwa Marine Electronics KR-1338C v.1 - Manual (Page 31)

2.16 Shifting (off centering) the Picture
Your vessel's position can be shifted up to 75% (not available on 48nm range)
of the range in use to view the situation around your vessel without changing
the range or size of targets.
Place cursor
Where desired
Press [OFF CENTER]
key to off center display
Cursor Cursor
Figure 2-12 Shifting the picture
1. Press the omnipad to set cursor where desired.
2. Press the [F1(A/C SEA)] control if its function is set for SHIFT (default se-
tting), or select SHIFT on the menu. OFFCENTER appears at the top right co-
rner of the display when the picture is shifted.
Cancelling shifted picture
Press the [F1(A/C SEA)] control again.
2.17 Zoom
The zoom feature allows you to double the size of the area between your vessel
and any location within the current range to take a closer look at an area of interst.
1.Select location with the cursor.
2.Press and hold down the [F1 (A/C SEA)] control about two seconds if its fu-
nction is set for Zoom (default setting), or select ZOOM on the menu, Zoom
appears at the top right corner when the ZOOM function is on .
23