OpenEye OE2-E120 - Manual (Page 22)

22
CONNECTING TO A SENSOR INPUT
To make connections on the Alarm Connector Strip: Remove the Alarm In block from the DVR for easy access. Use a small
screw driver to open the connection and insert the wire into the hole. To disconnect the wire loosen the connection with the
screw driver and pull the wire out.
Alarm In
Use external devices to send a signal to the DVR when an event occurs. Mechanical or electrical switches can be wired to
the Alarm In and Ground (GND) connectors.
Note All connectors marked GND are common. Connect the ground side of the alarm input and/or alarm output to the
GND connector.
CONNECTING TO A RELAY OUTPUT
To make connections on the Alarm Connector Strip: Remove the Alarm Out block from the DVR for easy access. Use a small
screw driver to open the connection and insert the wire into the hole. To disconnect the wire loosen the connection with the
screw driver and pull the wire out.
Alarm Out
The DVR can activate external devices such as buzzers or lights. Connect the external device to the Alarm Out and Ground
(GND) connectors. See Alarm Setup in the manual for more details.
TURNING ON THE DVR
1. Connect the power cable.
(See the Connection Guide section for more details) 2. Connect camera cables.
3. Connect a network cable and a monitor cable.
4. Flip the power switch on the back of the DVR and wait until the main screen is displayed on the connected monitor;
this process several minutes to complete.
SETTING THE REMOTE CONTROLLER ID
When more than one E-Series DVR is installed in the same location, you can use one remote controller to control multiple
DVRs – up to 20 DVRs. To control multiple DVRs, you must change the remote controller ID to the SYSTEM ID of the
DVR.
To change the remote controller ID:
1. On the DVR, go to SYSTEM > SYSTEM SETUP.
2. Enter the desired SYSTEM ID number.
3. On the remote controller, press and hold the ID button and enter the desired SYSTEM ID number to operate the
corresponding DVR.
Note The SYSTEM ID must be input as two numbers on the remote controller. Therefore you should input 00 for the
system ID 0 and input 01 for 1.