OpenEye OE2-E120 - Manual (Page 60)

60
Motion / Event Input
Motion / Event Setup allows you to enable recording or relay response on Motion, Sensor Event, and Video Loss
Motion
Enable– ON/OFF [Enable Event Input.]
Sensitivity – 1~5 [Define Motion sensitivity level. 1=least sensitive.]
Area – Red=selected, White=clear. Click to select/clear boxes.[Create or clear the motion area on the camera.]
Sensor
Sensor – ON/OFF [Enable recording on sensor event.]
Sensor Detail – All / 1~16 / All Channel [Associate sensors with channels. Select the All check box to associate all sensors
used to activate recording for that channel; Select the All Channel check box to associate the selected sensors with all
channels.]
Video Loss
VideoLoss – ON/OFF [Enable event on video loss.]
Video Loss Detail – All / 1~16 / All Channel [Associate video loss “V” alert with specific viewed channels. Select the All
check box to prompt all channels with video loss to provide a “V” alert to the viewed channel; Select the All Channel check
box to associate the selected channels to report a “V” alert when video loss occurs.]
HDD Setup
Disk Overwrite – Enable / Disable [Select the check box to enable the DVR to write over old data when the hard drive is
full.]
Disk Full Warning – Enable/Disable [Enable Disk Full Warning for notification when the HDD becomes full and HDD
Overwrite is disabled.]
Remain Time – 0~60 [Define the amount of remaining recording time to trigger the Disk Full Warning.]
Used Space – 80~99 [Define the percentage HDD used that triggers the Disk Full Warning.]
Disk Full Alarm – 0~8 [Define the relay that will trigger when the HDD is full.]
Disk Full Buzzer – Enable/Disable [Enable a continuous buzzer to sound for Disk Full Warning.]
Disk Full Message– Enable/Disable [Enable a popup message to display for Disk Full Warning.]
Sensor Setup
Sensor
Sensor – NO/NC [Set sensors to Normally Open or Normally Closed.]
Alarm Out – ON/OFF [Set Relay switches to Off or On.]
Note This section located in the Record > Event Setup section on the E120 server.