OpenEye OE2-E120 - Manual (Page 38)

38
Enabling Free DDNS
Your E-Series DVR comes with a free five-year DDNS service, pre-configured using OpenEyeDVR.com. DDNS service enables
the DVR to connect remotely to a server that does not have a fixed IP address.
Note
You must contact your network administrator to complete router configurations for the DDNS service to work.
1. Select NETWORK SETUP > NETWORK.
2. Select DDNS SERVER under DDNS and press ENT.
3. Select openeyedvr.com.
Note The DVR is preconfigured with the appropriate password and settings for the free DDNS service. If you load the
default network system settings refer to the DDNS information sheet for your DDNS settings. Please contact
Technical Support if assistance is required.
SERIAL SETUP
Configure connected serial devices.
SERIAL TYPE – Set External Controller or None.
MODEL – If External Controller is enabled, select the model
from the list.
PORT – Define port setting.
CLIENT SETUP
Configure general remote access
REMOTE PORT – Use this port number when configuring
remote access software. The default port is 2000 but can be
reconfigured.
WEB PORT – Used for remote connections using a web
browser. This port should be left open on the router. Default
web port is 80.
REMOTE CONFIGURATION – Enable to allow a remote
user to change configurations.
MAX TRANSFER SPEED – Set network bandwidth. If the
network is low speed, set this value as the network (aka.
Bandwidth Throttling).
2000
80
ENABLE
100 Mbps
NETWORK SETUP - CLIENT
SAVE CANCEL
NETWORK SERIAL CLIENT E-MAIL
REMOTE PORT
WEB PORT
REMOTE CONFIG
MAX TRANSFER SPEED