OpenEye OE2-E120 - Manual (Page 36)

36
MOTION DETECTION RECORDING
To record data only when motion is detected:
1. Press SETUP on the front of the DVR or remote control
and log in.
2. Select RECORD > EVENT SETUP.
3. Set MOTION to ON.
4. Set the motion Level. [NORMAL > HIGH > HIGHEST >
LOW].
5. Select AREA and press ENT to set a motion area
(global setting; each channel can be configured
individually).
6. Select USER SET to define a specific motion area.
7. Use the arrow buttons and the number buttons 1, 2 and
3 to navigate the motion area grid. (Selected motion
areas are highlighted green on the grid.)
1 = Set Mode 2 = Clear Mode 3 = Move Mode
a. Press 3 on the front of the DVR or remote control.
b. Use the arrow buttons to move the cursor to the
desired location on the screen.
c. Press 1 on the front of the DVR or remote control.
d. Use the arrow buttons to highlight the desired
motion detection area.
e. Repeat the steps above to create additional motion
detection areas.
8. When finished selecting motion areas press ENT on
the front of the DVR or remote control to save changes.
9. Repeat as necessary for each channel.
10. When motion area setup is complete select SAVE to
save settings and exit setup.