OpenEye OE2-E120 - Manual (Page 34)

34
MOTION/EVENT SETUP
Motion / Event Setup has four sections; Input, Sensor, Action, and EA (Emergency Agent). When and event comes in (Input) the
DVR records the image according to its settings (Camera Setup) and triggers an alarm (Action).
Input Setup
CH –  Channels 1~8 /  Channels 9~16
MOTION – ON/OFF [Specify whether to use motion input or
not.]
LEVEL – Low / Normal / High / Highest [Sensitivity]
AREA – Define the motion detection area.
SENSOR/VIDEO LOSS – Specify ON/OFF for each type of
event.
Note For Motion Area settings see Motion Detection
Recording later in this manual.
Sensor Setup
Sensor Setup
1. Use the arrow buttons to select Sensor 1 and press
ENT to change to N/O (Normally Open) or N/C
(Normally Closed).
2. Repeat for all sensors.
3. Select SAVE and press ENT to save settings and exit
SENSOR SETUP.
Relay Setup
1. Use the arrow buttons to select Relay 1 and press ENT
to turn OFF and ON.
2. Repeat for all relays.
3. Select SET and press ENT.
4. Select SAVE and press ENT to save settings exit
SENSOR SETUP.
NO.
1
2
3
4
SIGNAL
ON
ON
ON
ON
SET CLEAR
NO. 
1
2
3
4
5
6
7
8
TYPE
N/O
N/O
N/O
N/O
N/O
N/O
N/O
N/O
MOTION/EVENT SETUP - SENSOR
SAVE CANCEL
INPUT EA SENSOR ACTION
9CH-16CH