OWON SDS Series - Manual (Page 80)

5.Advanced User Guidebook
Figure 5-71 Waveform of Voltage Cursor Measurement
Carry out the following operation steps for the time cursor measurement of the
channel CH1:
1. Press Cursor and recall the Cursor Measure menu.
2. Press the H2 button and choose CH1 for Source.
3. Press the H1 button, the Type menu will display at the right of the screen.
Press the F3 button to select Time for Type, with two purple dotted lines
displayed along the vertical direction of the screen, which indicating Cursor
1 and Cursor 2.
4. According to the measured waveform, adjust the positions of Cursor1 and
Cursor2 by turning the VERTICAL POSITION knob of CH1 and CH2.
The cursor increment window at the left bottom of the waveform shows
absolute difference, frequency and the present time of the two cursors.
75