Desa CGMFP - Manual (Page 12)

www.desatech.com 119315-01A 1
iNsTallaTioN
Continued
Mantel Shelf
3
1
/ 4
"
6" 9" 18"
3/4"
1"
3"
9"
Note:
All vertical
measurements
are from top of
fireplace
opening to
bottom of
mantel shelf. All
measurements
are in inches.
Figure 9 - Minimum Mantel Clearances
for Built-In Installation
OPTIONAL MANTEL INSTALLATION
Refer to instructions provided with the mantel for
assembly. Refer to the following instructions for
system installation. Refer to instructions on page
6 for hood assembly.
1. Assemble cabinet mantel as shown in acces-
sory instruction sheet.
2. Place hearth base against wall at installation
location. Cut an access hole in hearth base to
run gas line to fireplace (see Figure 10). Make
sure to locate access hole so cabinet mantel will
cover it when installed. Note: You can secure
base to floor using wood screws. Countersink
screw heads and putty over.
3. Route flexible gas line through access hole in
hearth base.
4. Center cabinet mantel on hearth base (see
Figure 11). Make sure mantel is flush against
wall and centered left to right on base.
5. Use hardware provided with mantel accessory
to attach mantel assembly to base (see mantel
instruction sheet).
6. Attach flexible gas line to fireplace gas regula-
tor. See Connecting to Gas Supply, page 13.
7. Check all gas connections for leaks. See
Checking Gas Connections, page 15.
8. Carefully insert fireplace into cabinet mantel
(see Figure 12). Be careful not to scratch or
damage hearth base or cabinet mantel (see
manual instruction sheet.
Side of Firebox
Figure 10 - Placing Hearth Base Against Wall
Hearth
Base
Electrical
Outlet Pipe and Gas
Shutoff Valve
Figure 11 - Installing Cabinet Mantel onto
Hearth Base
Cabinet
Mantel
Hearth
Base
Figure 12 - Installing Fireplace into
Mantel Assembly
Cabinet
Mantel
Hearth Base