Installation – Desa CGMFP User Manual

Page 16

Advertising
background image

www.desatech.com

119315-01A

16

iNsTallaTioN

Continued

PRESSURE TESTING FIREPLACE GAS
CONNECTIONS

1. Open equipment shutoff valve (see Figure 16,

page 15).

2. Open main gas valve located on or near gas

meter for natural gas or open propane/LP

supply tank valve.

3. Make sure control knob of fireplace is in the

OFF position.

4. Check all joints from equipment shutoff valve

to gas regulator (Manual-Controlled Models)

or to gas control valve (Remote-Ready Mod-

els) (see Figures 17 or 18, page 15). Apply

noncorrosive leak detection fluid to all joints.

Bubbles forming show a leak.

5. Correct all leaks at once.

6. Light fireplace (see Operating Fireplace, page

18). Check all other internal joints for leaks.

7. Turn off fireplace (see To Turn Off Gas to Appli-

ance, page 20 for Manual-Controlled Models

or page 21 for Remote-Ready Models).

OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
Remote-Ready Models Only
(HRC100 & HRC200 Series)

Installing Receiver
1. Disconnect jumper wire from control valve

(see Figure 19).

2. Locate battery clip mounted on back of re-

ceiver (see Figure 20).

3. Slide 9-volt battery (not included) through

clip.

4. Attach terminal wires to battery (see Figure 20).

5. Connect wires from remote receiver to control

valve as shown in Figure 21.

6. Install remote receiver unit onto remote bracket

using screws provided (see Figure 21).

Figure 21 - Installing Remote Receiver

Remote
Receiver

Figure 19 - Disconnecting Wires From

Control Valve

Figure 20 - Attaching Battery to Receiver

Battery Clip

9-Volt
Battery

Receiver

Terminal
Wires

Control
Valve

Jumper
Wire

White Wire
to TPTH
Terminal on
Control Valve

Red Wire to TH
Terminal on Control
Valve

Installing 9-Volt battery in Hand-Held
Remote Control Unit

1. Remove battery cover on back of remote

control unit.

2. Attach terminal wires to the battery (not

included). Place battery into the battery

housing.

3. Replace battery cover onto remote control

unit.

Figure 22 - Installing Battery in Hand-

Held Remote Control Unit

9-Volt Battery

Battery
Housing

Battery Cover

Terminal
Wires

Remote Control Unit

Advertising
This manual is related to the following products: