Teac DR H338i - Manual (Page 23)

23
EN
G
LI
SH
Pausing playback
During playback, press the Play/Pause button (G/J). Playback
stops at the current position.
< To resume playback, press the Play/Pause button (G/J) again.
Skipping playback
During playback, press the Skip buttons (.//) repeatedly
until the desired song is found.
< When the Skip button (.) is pressed during playback, the
current song will be played from the beginning. If you want to play
the previous songs, press the Skip button (.) twice or more.
Searching for a part of a song
Hold down
During playback, hold down the Search button (m or ,) and
release it when the part you want to listen to is found.
1
Press the SOURCE button to select “iPod”.
< You can also select iPod by pressing the iPod/USB button on the
remote control unit once or twice.
2
Insert the iPod into the dock.
The iPod automatically turns on and starts playback from the
iPod’s music list.
< When the iPod is inserted while a source other than iPod is
selected, the iPod will turn on and enter the pause mode.
< Make sure to use an appropriate dock adapter (see previous
page).
< The iPod is recharged when it is plugged into the dock and
the DR-H338i is on. While the unit is on standby, the iPod is not
recharged because the unit’s power consumption is minimized
to meet the regulation of IEA.
< When headphones are plugged into the iPod, sound comes
from both the speakers and the headphones.
< The video signal from a connected iPod is output only from the
video output terminals of DR-H338i.
Listening to an iPod (1)