Teac DR H338i - Manual (Page 39)

39
EN
G
LI
SH
DIGITAL AUDIO SETUP (DIGITAL OUTPUT)
OFF
Select this when you do not use the DIGITAL OUT.
No signal is output from these terminals.
ALL
Select this when the unit is connected to an audio component
equipped with a built-in Dolby Digital decoder via the DIGITAL
OUT or the HDMI out terminal.
PCM only (Default)
Select this when the unit is connected to an audio component
such as amplifier/receiver, CD recorder or MD deck via the DIGITAL
OUT or the HDMI out terminal.
DOLBY DIGITAL SETUP (DUAL MONO)
STEREO
Left channel is output from the left speaker, and right channel is
output from the right speaker.
L-MONO
Left channel is output from the front left and right speakers.
R-MONO
Right channel is output from the front left and right speakers.
3D PROCESSING
This setting provides following sound effects:
OFF
CONCERT
LIVING ROOM
HALL
BATHROOM
CAVE
ARENA
CHURCH
Settings (AUDIO SETUP)
NIGHT MODE
ON
Applies dynamic range control to Dolby Digital material, reducing
the volume of loud sounds, and increasing the volume of quiet
ones. This is useful for spoken word material, and nighttime
listening etc.
OFF (Default)
Turns off the audio dynamic compression.
< This function is effective only when playing back a DVD disc
recorded with Dolby Digital. This control has no effect on other
discs.
< The overall effect of this setting depends on the disc being played,
the amplifier, and the speakers used for reproduction.
AUDIO SYNC
This setting can cause delays in the sound signal in 10 ms increments
ranging from 0 ms to 200 ms (only for digital signals recorded on a
disc or stored in an USB device; unavailable for analog signals coming
from AUX 1 or 2).
Depending on the TV, it may take approximately 100 ms (0.1 sec.) for
an image to appear after video signals are input, causing the image
to appear after the sound coming from the DR-H338i is heard.
If this happens or audio and video synchronization creates a less
than optimal viewing experience, adjust the delay with the left
(decrease) or right (increase) Cursor buttons (g/t).