Cd recorder, Cassette tape recorder – Teac AD-RW900-B User Manual

Page 49

Advertising
background image

49

ENGLISH

CD Recorder

Will not play

e Load a disc with the label side up.
e If the disc is dirty, clean the surface of the disc. If the disc is

scratched or has any sticky substance on its surface, do not play
the disc until you have corrected the condition of the disc. Never
under any circumstances use after-market stick-on labels or “disc
enhancement” devices that sit on top of or wrap around a disc.

e If a blank disc has been loaded, load a prerecorded disc.
e Depending on the disc and other factors, playback of some

CD-R/RW discs might not be possible. Try again with another disc.

e You cannot play unfinalized CD-R/RW discs. Finalize such a disc in

a CD recorder and try again.

e If moisture condensation has occurred inside of the unit, leave

the unit for one or two hours with the power turned on.

Sound skips

e Place the unit in a stable place to avoid vibrations and shocks.
e If the disc is dirty, clean its surface.
e Do not use scratched, damaged or warped discs.

Recording is not possible.

e A playback-only disc or finalized disc has been loaded. Use a

recordable disc.

e The recording level is too low. Adjust the recording level.
e The remaining recording time of a CD-R is not sufficient. Use

another disc.

e If the remaining recording time of a CD-RW is not sufficient, erase

the last tracks or replace the disc.

e Synchronous recording does not start if the sound coming in is

quieter than the auto track level.

The numbers and lengths of tracks differ from those of the
original tracks.

e The unit recognizes the beginning of a track by detecting the

auto track level of sound. The track number may not be applied
to the silent part.

Continued on the next page

Cassette tape recorder

Cassette tape compartment does not close.

e The cassette tape is not properly loaded. Reinsert it.

Sound quality is poor

e Clean the heads (page 6).
e If a head is magnetized, demagnetize it with a head demagnetizer.
e Check that the Dolby NR switch is set to the same position as

when the recording was made.

Playback speed seems somewhat fast or slow.

e Check the pitch control setting (page 30).

Auto reverse does not occur.

e Set the REV MODE switch to j or p.
e If the REV MODE switch is set to j, start playback from the tape

side facing you (“side A”).

Cannot record

e If the erasure prevention tabs on top of the cassette are broken

off, cover the holes using pieces of adhesive tape.

e Check the recording level setting (page 43).

USB

No sound even if the USB Play/Pause (t/J) button is pressed

e Confirm that there are MP3 files on the USB flash drive.
e File formats other than MP3 (e.g. MPEG 1 LAYER 2 file) and WMA

cannot be played.

Cannot record

e Confirm that the USB flash drive has free space.
e Confirm that the USB flash drive is not locked.
e When record from an analog source, check the recording level

setting (page 40).

Advertising
This manual is related to the following products: