Tri Tool 602-5SBM Clamshell Air User Manual
Page 14
14
TRI TOOL INC.
92-0093 Rev. 131230
NOTE:
Clamshell Cross Section
DRIVE GEAR AND MAIN GEAR LUBRICATION
Remove the Drive Housing.
Inspect both Drive and Main Gears for chips or burrs and clean as required.
Coat the teeth of the Drive Gear and the Main Gear with a grease which is approved
by Tri Tool. Refer to the lubricant recommendations located later in this section.
TOOL BLOCK MAINTENANCE
Clean the Slide Rails, the Feed Nut, the Sprocket Assy. and the Feed Screw.
Inspect these parts for damage and replace as required.
Lubricate and reassemble the Tool Block. Refer to the picture Tool Block Assembly.
Use lubricant on the Feed Screw sparingly or wipe to a film condition.
Excess lubricant will collect grit and/or chips and tend to cause thread jamming
and/or damage.
Adjust the adjustable Slide Rail to provide a firm, but not excessive rotational
pressure on the sprocket.
HEADSTOCK
THRUST
PLATE
HOLD-DOWN
SCREWS
MAIN
GEAR
MAIN
BEARING
HOUSING
RACE
HOUSING
CAVITY
THRUST
PLATE
SEVER
LINE