Tri Tool 602-5SBM Clamshell Air User Manual
Page 15
Advertising
![background image](/files/808026/content/doc015.png)
15
Model 602.5SBM, Low Profile Clamshell
92-0093 Rev. 131230
NOTE:
Tool Block Assembly
The Slide Rails must be over-tightened to squeeze the oil into a thin film against the
male and female surfaces of the Slide Rails.
Reset for proper operation.
If the Mounting Bracket has been overstressed, the Slide Rails may appear
to loosen when mounted if they were adjusted off of the Clamshell.
Adjustment when mounted provides the most satisfactory results.
TOOL HOLDER ADJUSTMENT
Loosen the Hold-down Screws on the Adjustable Slide Rail.
Run the Tool Holder to the most outward position.
Using the Adjustment Set Screws, apply a light force to the side of the Adjustable
Slide Rail so that it is in positive contact with the Tool Holder.
Advertising