Tri Tool 602-5SBM Clamshell Air User Manual
Page 22
22
TRI TOOL INC.
92-0093 Rev. 131230
CAUTION:
Rough center and square the Clamshell by tightening the four Clamping Pads
independently.
Check the center and squareness by eye.
The Adjustable Pads tend to square the Clamshell to the pipe.
If additional precision in squaring is required, consult Tri Tool about alternate
methods of squaring.
Fine center the Clamshell as you would a 4-jaw check.
Take measurements from the pipe OD to the Housing ID or use a dial indicator to
sweep around the pipes outside diameter.
Adjust the four Clamping Pads so that the measurements at opposing Clamping
Pads are the same.
GENERAL MACHINING SEQUENCE
To set Tool Bits, go to “Tool Bit set up”, for set up instructions.
Install the Air Motor into the drive socket and bolt it to the Clamshell.
There are 6 various orientations available so that clearance for the Air Motor may be
obtained. Refer to the picture “Air Motor alternate positions”.
The Motor Mount reacts the torque of the Air Motor only when the Motor
Holddown bolt is in place.
1
2
3
4
5
6
Air Motor Alternate Positions