Tri Tool 602-5SBM Clamshell Air User Manual
Page 25
Advertising
25
Model 602.5SBM, Low Profile Clamshell
92-0093 Rev. 131230
Mount the Tool Blocks and Tripper Block to the Clamshell.
Check the adjustment of the slides and mesh of the Tripper Pin with the Feed
sprocket.
Select the proper Clamping Pad Set.
Install the Clamping Pad Set into the Clamshell.
If using the Fixed Clamping Pad Set then install the Clamping Pad Set so that the
pipe lays on the Fixed Pads or vice versa.
Fixed Pads should be located 90 degrees from each other.
Tool Block Selection
Tool Block
Assy
Height from Centerline of the
cut to the Headstock Face
Tool Block Travel
08-0036
1.50"
38.1 mm
.63"
16.0 mm
08-0096
.51"
13.0 mm
.40"
10.2 mm
Advertising