Warning – Tri Tool 602-5SBM Clamshell Air User Manual
Page 23
23
Model 602.5SBM, Low Profile Clamshell
92-0093 Rev. 131230
NOTE:
WARNING:
NOTE:
Approach of the Feed Pin to the Feed Sprocket
Check that the air supply filter/regulator/lubricator is installed and set properly.
Check for proper alignment of the Feed Sprockets. Refer to the picture “Approach of
the Feed Pin to the Feed Sprocket”.
Run the Headstock slowly with the Feed Pin ‘in’ to insure that the Sprocket is set
right. (Do not run at full speed during the first revolution.)
You will break the Feed Pin if the Feed Pin to Sprocket alignment is incorrect.
WARNING
DO NOT OVERIDE THE DEADMAN SWITCH
ON THIS UNIT. Locking down, obstructing, or
in any way defeating the deadman switch on
this unit may result in serious injury.
Deadman Switch Warning
Turn on the Air Motor to full speed by opening the Throttle control Valve.
The Air Motor working speed will be about one half of the no-load speed.
(Refer to “Cutting Speeds” for speed selection chart).
Engage the feed by pushing the Tripper Shaft in.