Tri Tool 602-5SBM Clamshell Air - Manual (Page 27)

27
Model 602.5SBM, Low Profile Clamshell
92-0093 Rev. 131230
Tool Bit Adjustment
After the sever is completed, reposition the Bevel Tool Bit so that it continues cutting
until the desired land thickness is obtained.
Go to “Monitor the cutting operation”.
SOCKET WELD REMOVAL
Install the Tool Bit in the Socket Weld Tool Holder (Optional) as shown. Refer to the
picture “Socket weld removal”.
When the Tool Bit first cuts the parent metal, stop the machine and retract the Tool
Holder.
Strike the pipe end and twist it out of the socket.
If the pipe will not separate from the socket, then continue cutting.
After every 3 to 4 revolutions, try again to break the pipe free.
SEVERING AND SINGLE BEVELING OR SEVERING AND DOUBLE BEVELING
SIMULTANEOUSLY
When the Tool Bits are within about .040” (1.02 mm) of severing the pipe, disengage
the Feed Pin and let the Headstock rotate 2 to 3 times to clear the chip.
Retract the Tool Holder which holds the Bevel Tool Bit, be sure that the Feed
Sprocket is aligned properly. Refer to the picture “Tool Bit adjustment”.
Complete the sever.