Verilink SCC 2130 (880-503282-001) Product Manual - Manual (Page 29)

Configuration
Verilink SCC 2130 User Manual 3-9
Node Administration
In addition to the T1 CSU/DSU functions, the SCC 2130 is also an
SNMP node controller. The Node Administration Menu, and
submenus beneath it, are used to configure site, Ethernet and SLIP
address and information.
Some functions on the Node Administration Menu support
firmware upgrade procedures.
Node
Administration
Menu
The Node Administration Menu is accessed by selecting O on the
SCC 2130 Main Menu.
Figure 3-3 shows the options presented.
Most of the commands on the Node Administration Menu are
documented in
Table 3-5 below.
Some of the menu options on the Node Administration Menu will
produce submenus with detailed selections, the Modem
Configuration Menu is detailed in
Table 3-6 .
G) Alarm Determines whether
or not alarm
messages are
presented.
0(Disable) — Alarm reporting is turned off.
1(Enable) — Alarm reporting is enabled, messages will
appear on the Craft terminal as alarms occur and clear.
V) Data Invert Sends ones as zeroes
and zeroes as ones.
If used at one end of
a T1, must be used at
both ends of the T1.
Data inversion is sometimes used to manipulate ones
density. If it is known that the data from a particular DTE
will always have more zeroes than ones, data inversion will
make it have more ones than zeroes. Use of this option to
attempt 64K per DS0 bandwidth over an AMI facility is not
recommended.
X) exit menu Exit this menu. Returns to the SCC 2130 Main Menu.
Menu Option Description Instructions