Verilink SCC 2130 (880-503282-001) Product Manual - Manual (Page 34)

Configuration
3-14 Verilink SCC 2130 User Manual
Table 3-6 Modem Configuration Commands
Firmware Upgrade Procedures
Firmware upgrades performed using an SCC 2130 may be divided
into two categories: upgrades of the SCC module’s own firmware,
and upgrades in which the SCC broadcasts new firmware to other
module(s) in the node.
Menu Option Description Instructions
D) Answer Toggles answer mode
on/off.
Select ENABLE to support answering incoming calls.
Select DISABLE to inhibit answering calls.
C) Answer Command Command string to be
sent to modem to setup
auto-answer mode
The default auto-answer string is shown in Figure 3-4 ,
use this string or modify it per the requirements of
your modem.
T) Answer Inactive
Timeout
Length of time an
incoming call is allowed to
be idle before the modem
is disconnected.
Enter a value, in seconds, for idle time before
disconnect (range = 1 to 255), if this value is reached,
the DTR lead is toggled low to disconnect the modem
(modem should be set for [&D2] disconnect on DTR
low).
B) Dial-Out Toggles on/off dialing a
stored number to report
alarms to a trap host.
Select ENABLE to support dialing out to a trap host
when alarm conditions occur and clear. Select DISABLE
if the SCC 2130 is never to dial out to a trap host.
U) Dial-Out
Command
Command sent to modem
to initiate a call.
The default dial-out string is shown in Figure 3-4 , use
this string or modify it per the requirements of your
modem and phone line.
N) Dial-Out Number Phone number to call. Enter a phone number if using dial-out.
R) Dial-Out connect
retries
Number of times to retry
dialing out to trap host.
Enter a number in the range of 1-255, or zero to
disable the retry function.
K) Dial-Out connect
timeout
Length of time to wait for
a connection after
initiating a dial-out call.
Enter a value, in seconds, to wait for a connection
after dialing a call to a trap host, range = 10 to 255
seconds.
I) Dial-Out Inactive
timeout
Length of time a dial-out
call is allowed to be idle
before the modem is
disconnected.
Enter a value, in seconds, for idle time before
disconnect (range = 1 to 255). If this value is reached,
the DTR lead is toggled low to disconnect the modem.
To support this selection, the modem should be set
for [&D2] disconnect on DTR low.
S) Dial-Out Command used for
testing.
The Dial-Out command causes the modem to dial
now.
W) Set default
commands
Rests all modem menu
items to default values.
Use this command to set all options on this menu to
their original, factory default values, disables modem.
A) Answer Sends answer string. Use this command to set modem to answer mode by
sending the configured answer command now.
H) Hangup Disconnects modem. Causes modem to disconnect now by dropping DTR.
X) exit Exits to menu above. Returns to Node Administration Menu.