Vinpower Digital Titan Lightscribe Autoloader - Manual (Page 37)

35
Setup
1.Language
Language:
English
Language:
Espanol
Setup
2.Read Error Skip
Read Error Skip
On
Read Error Skip
Off
Read Error Skip
Off with Retry
Read Error Skip
Turbo
In order to display this information, a LightScribe printable disc (printing side face down) must be manually
placed into the LightScribe printing device before performing this function.
12.5 Label Info
The Label Info function provides in-depth information as to what type of LightScribe media is supported by
this label file. This function is only needed for troubleshooting purposes.
13. Setup
The Setup menu options are used to configure various options on the autoloader. Each of these options is
discussed in its own subsection.
13.1 Language
This setting allows you to choose the language that you prefer to use when navigating the autoloader. The
autoloader supports multiple languages.
Use the Up or Down button to select the Language menu and press
the ENT/Enter button to enter that menu.
Use the Up or Down button to select between the languages and
press the ENT/Enter button to select that option.
13.2 Read Error Skip
Normally, when the autoloader encounters a read error while reading your master disc, the duplication is
aborted and all the recordable media in the writers are ruined. However, if you believe that your master disc
has a small, insignificant error due to physical damage, you can enable this setting to allow the autoloader
to skip any read errors it encounters.
Note: This function does not fix the error; it only skips it to make the rest of the data readable.
Use the Up or Down button to select the Read Error Skip menu and
press the ENT/Enter button to enter that menu.
Use the Up or Down button to select whether Read Error Skip is On,
Off, Off with Retry or Turbo and press the ENT/Enter button to select that
option.
 On: By select this setting, you instruct the system to skip any
Read Errors during the duplication process.
 Off: By select this setting, you instruct the system to fail the
entire duplication process when a Read Error occurs.
 Off with Retry: By select this setting, you instruct the system to
perform additional retries when a Read Error occurs,
however, upon retry attempt failed, the entire duplication
process will be failed.
 Turbo: By select this setting, you instruct the system to skip any
Read Errors in a large step during the duplication
process.